Wiring pyro
Thread Starter
Registered User
Joined: Jan 2003
Posts: 34
Likes: 0
From: Elko, Nevada
Wiring pyro
After reading that the pyro hot lead should be wired into a keyed hot while cranking circuit I was wondering if anyone could save me some work 
and tell me where they tapped in at?
Thank You,
Ben
and tell me where they tapped in at?Thank You,
Ben
Registered User
Joined: Jun 2006
Posts: 158
Likes: 3
From: Perdido Beach, Alabama
Pyro Wiring
When I installed my gauges, I ran the red wire to behind the fuse panel and spliced it into the wire that powers the turn signal can. If I remember right it is a brown wire.
Pull the flasher can and use a test light or volt meter to see which one has 12v with the key on.It does not have to have 12v to the gauge while cranking, only running.
I hooked the gauge lights up to the headlight switch so they dim with the dash lights.
Pull the flasher can and use a test light or volt meter to see which one has 12v with the key on.It does not have to have 12v to the gauge while cranking, only running.
I hooked the gauge lights up to the headlight switch so they dim with the dash lights.
Thread
Thread Starter
Forum
Replies
Last Post
53 willys
3rd Gen High Performance and Accessories (5.9L Only)
11
Sep 7, 2010 10:52 PM
charcoal600
Towing and Hauling / RV
2
Apr 30, 2005 02:34 PM