Mach 4 Install Help

Reply Subscribe

Thread Tools

Search this Thread

May 13, 2010 | 09:05 PM

CODODGE2500MAN

Thread Starter

Chapter President

Joined: Oct 2004

Posts: 978

Likes: 0

From: Highlands Ranch, Colorado

Mach 4 Install Help

Welp, now that I got the stupid CKP sensor fixed, I'm heading toward the Mach 4's...

Anyone want to come help that knows how to do it? I'll be in Grand Rapids, MI until December 2010 and then I'll be back in the Denver, CO area...

Or, anyone know of a shop (& how much they'll charge/should charge?) near either Grand Rapids or Denver?

May 14, 2010 | 09:26 AM

HOHN

Registered User

Joined: Apr 2003

Posts: 6,564

Likes: 6

From: Cummins Technical Center, IN

Sorry, I'm not even close to you. Want to swing through Indiana?

May 14, 2010 | 12:23 PM

J Lent

Banned

Joined: Apr 2007

Posts: 3,309

Likes: 1

From: East Millsboro, PA.

One hour shop rate time, 1 1/2 hours if they are slow. About $75-$100 to install them. Shoot by PA, I'll do them.

May 16, 2010 | 10:26 PM

DodgenIt

Registered User

Joined: Apr 2007

Posts: 990

Likes: 0

From: SLC, Ut. 4,200 ft.

Injector swap isnt too hard on its own.
Look it up on you tube, I watched a few videos on there and went at it and turned out good after about 2 hours.