okay just got done working on putting in a fuel pressure gauge. One thing is it's leaking bad and for the moment i had it on i had about 7 PSI at idle, got a ball vlave so it's shut off. Put the banjo bolt in and it was simple straight forward. no problems. Okay next issue, i cycled the LP 5 times or so and went to start, ran a couple seconds and died. so i tried cycling for a while more, still nothing. Cracked a couple lines and got fuel to them, then i got it to run and it died again however i did this for probably an hour and a 1/2, needless to say my batteries are getting old, didn't have enough juice to get started again. So i had to jump it because i don't have a battery charger at the moment, it's at my parents house over 4 hours away. Anyways, so i hooked it up and she cranked, well wouldn't start so i stepped on the go pedal since i've read some people on here doing that. She started and is going great now other than my gauge is leaking so i got to get it plumbed a little better. My main problem though is my speedo is maxed out, pegged clear past 120 and doesn't move, What's up? I'm scared I messed up something in the computer, please give me some answers quick? I'm going to do the key trick and see if it says anything?

 

did the key trick and only code i got is the PC1693. Which i know is a companion code, so i guess i'll have to go to the dealer tomarrow or something unless someone knows something i don't. Please help me out.

 

NVR mind. I did the gauge check reset by holding the trip reset button and turning the key and ended up fixing the problem. I figured out my own problem, i'm so happy when i can do that. lol.