So as some of you may know, I bought a custom 12mm p-pump a while back and had issues with it. Sent it back, apparently they couldn't find anything wrong with it. So now I have it back. I'd like to find someone to run it and see if its any better or not, and let Harry know. My dually is pretty much done for the season, and I'd like to keep my 12v intact since its the daily driver.

So, anyone want to give this a go? I'll help swap it in and out, I just don't want to take my trucks any further apart.

 

more than welcome to chuck it in mine........ bet it make lots of noise, but won't go very far.

 

lol Wish I had my 24 valve ready to go.

 

Only if had some 24V P pump lines, I would be game to try it out.

 

What was the problem with that pump???As I remember you couldn't get it to fuel properly....Even with the laser cuts...That was a 160 pump that was modded??We maybe be able to test it on my truck if you like..

 

It had governor issues, either with not enough fuel or a poor idle. It wasn't any better than my stock 215 pump. I just want to fire it on a truck, see if its the same, and if it is, I might send it south for a tune up.

 

i would be send it south and send the bill west lol

 

That would be ideal.