Torque tube mod
#3
i have a homemade.
Homedepot all the way
just used 2 abs 4" couplers and a piece of 4 inch pipe on the inside for strength. you can see there is no gap between the couplers so the pipe inside is about 3" long. the two couplers OL is about 1/16 less than the actual toque tube. and in diameter about an 1/8 of an inch. i ran a few raps of electrical tape on the ends to get the diameter i wanted then cranked down on the pipe clamps. did nothing for performance but definatly a little louder with the turbo.
Homedepot all the way
just used 2 abs 4" couplers and a piece of 4 inch pipe on the inside for strength. you can see there is no gap between the couplers so the pipe inside is about 3" long. the two couplers OL is about 1/16 less than the actual toque tube. and in diameter about an 1/8 of an inch. i ran a few raps of electrical tape on the ends to get the diameter i wanted then cranked down on the pipe clamps. did nothing for performance but definatly a little louder with the turbo.
Thread
Thread Starter
Forum
Replies
Last Post
jamesbfishin
3rd Gen Engine and Drivetrain -> 2003-2007
6
07-07-2007 08:25 PM
wap
3rd Gen High Performance and Accessories (5.9L Only)
14
04-23-2007 06:46 PM
Buffalo
3rd Gen High Performance and Accessories (5.9L Only)
5
11-28-2005 03:53 AM
RAMV
3rd Gen High Performance and Accessories (5.9L Only)
9
07-14-2004 12:08 PM