This is a different sort of question, I've searched a bit for it and can't find an issue.

I've run the Smarty for about a year and a half now and am wanting to change settings.

Is there anything to look out for since I've not used it in so long? I think I've plugged the Smarty up a grand total of 3 times and not used it since!

 

You will have less smoke with the new programs,

 

Thanks for the reply Bob.

I actually went ahead and updated to SW3 using the program I had with Stock TM and aftermarket injectors. The smoke is very controllable, nearly equivalent to my old settings. Power is certainly up and I understand what people mean when they say the response feels a lot like a big block gas engine.

When I first updated there was a problem and I had to use the recovery program. I don't know what caused it but I did have a recurring P0513 code which may have had something to do with it, not sure. I went for a drive and put a few starts on the truck with no problems.