Just like it says the RP guage is reading a zero it has power is grounded lights up checked the conection on the rail sensor all seems good but getting a big fat zero it has been on the truck about a week and been driven 15 miles in that week any ideas stumped here

 

I think reading these forums there have been maybe 6 people who Quad RP hasnt failed.

 

i am starting to think i wasted 140 on it i tried everything pulling plugs grounds and still getting a zero i do have two wires that are not connected at the little black box they are green and yellow does anyone who has one have the same thing where the wires go into the guage unit those two are not hooked up

 

just got off the phone with quad bad circuit and i need to go thew DTR to get it replaced???? why dont they send me one its their product not dtrs?

 

that's strange, i had this happen to me twice. both times i sent it back directly to quad and they sent me another one. i'd call them back and ask them why there making you do that. it doesn't make sense.

 

i'd also consider sending it back to the company you bought it off of and getting a refund. $140 seems pretty steep. i got mine for $106.

 

Same here. I sent it back to Quad all four times.... I've finally given up on it. When I removed the harness my slightly rough idle improved.

 

same problems here 3 gauges so far all have quit and read 0. I love the look of the gauge and the digital readout is easy to see, they just dont last.

 

Its truly unfortunate. It was a great idea quad had and was MUCH appreciated by many people. When the alternatives are $300+ for the same thing it seemed like a no brainer.

Wish it would have worked better. Caused me a bunch of issues and into the trash it went.

 

i have the control pod from quad that runs my x2 race module. i have had no rail gauges issues with it. i have had the module lock up, and the truck quit running, but that only requires a restart, and it is very infrequent..

 

so what is a good alternit to the quad one i need to see my RP