okay guys,
I got my quad box (xzillaraider) hooked up to my truck but i lost the switch for the 5 settings. Without the switch, does this box revert to the lowest, 25HP?

also, maybe QUAD can chime in and let me know why this connector wont fit my coolent temp plug. This box came off my old truck, also an 03, but this plug on the truck is smaller then the plug on the box...... Plug on the truck is a small 2 wire plug and the plug on the box is a large 3 wire plug with only 2 wires on it.



Thanks
folks

 

First picture is the plug on the quad box.
Second is the coolent sensor on the truck

 

Post a picture of what the box looks like. That looks like the older xillerator std. harness.

 

It is the old one. Built on 05. Yellow box. its way cold outside (5 degrees) so a picture wont come tonight

 

That means you don't have a wire that connects to the cooling system. My old box was Green, the newest boxes are black. You have two plugs that you need, the map sensor and the high pressure sensor, that's it. As far as the switch, perty sure you gonna need that. Give Quad customer care a call.

 

Odd. I have the MAP and rail pressure sensor plugs, pluged in already. Obviously have the switch plug open. and have that one remaining.
Any idea what its supposed to be for?

 

Yes, it was a data link cable plug I think. That's been a long time. Tape it up, you don't need it.

 

Good to know. Thanks for your input.

 

Do you need a switch for the box?

 

Yeah. mines trashed. i think quad can supply pne for $10 though.

MAN ive only posted 80 some times?!?! God i read WAY more on this site then i post

 

I run into that same problem!

Did know they were so cheap; in light of that I will ship it to you if you want it.

 

Thanks for the offer but i think im going to mail quad my standard box and upgrade to the xzillaraider II (with minor additional cost).


Thats another cool thing quads got goin for them

 

The upgrade is a good idea. They sent the new and improved switch to me when I upgraded my friends for no additional cost other than the upgrade cost.

 

have you tried any of the other downloads they have on the site? do you know if those downloads are dedicated to just the 1st position on the switch or can you designate where it goes?
hope that makes since.

 

Check out the website. I know you cannot create your own choice but they do have have downloads that assign the 1st setting for a specific choice then the others for what they have assigned.

That will make more since once you see the choices on the

http://www.quadzillapower.com/produc...-3-USB-Updates