has anyone ever seen a pillar gauge pod that can hold the edge/attitude and maybe 2 standard round gauges?

 

Just "stick" the Attitude over one of the 2" round opinings in a triple a pillar?

 

Ya,
I thought about doing that but it might look kinda tacky. I am a machinist so maybe I will just make a nice billet attitude mount with a round lug on the back to go into the regular pillar holes. I was hoping maybe someone had seen one somewhere but I havnt seen any...............

 

JCROMAN,

We have the full A pillars that hold an Attitude and 1 gauge, most folsk only wanted the fuel pressure that the Attitude doesn't offer etc. These are color matchd and bolt on in place of the stock pillar.

Mark @ DPPI

 

Hey Mark
Are they going to make a A-pillar mount for the A2?

 

because the A2 is so big, I really don't think many folks will want it right in their line of site while turning. Its very difficult to see around.

 

Its All Good,

We've talked about it but it's just too large for the A pillar. We are looking at other options though.

Mark @ DPPI