guys hitting the dyno again tomorrow, last time it was 653 in sw9.this time ive added a mp-8, a stage3 floor it,springs,and adjusted the twins to push 62psi, instead of 52psi.also last time i was only able to hold 19,000 for r/p in sw9.thanks

 

712, 1550 ft lbs ...... and a big smile on the drive home.

 

700hp would be sweet, you and I have about the same setup. Does it "feel" 50hp faster now with the new additions? I'm dynoing in a week or two, it will be interesting to compare.

 

it definately feels at least 50hp, just the mp8 alone feels like my old edge when going up in levels on the fly.

 

good luck and have fun!

 

just got back from dyno,my settings were sw3, sw7,and sw9 run's.i backed off on the timing a little because of all this to much timing talk latley.timing3 insted of 2.and i also replaced the meth with all water, so i lost 22hp right there, and had the mp-8 on 30 to 40 %.sw3 was 619hp,sw7 was 660hp, and sw9 was 683hp.i feel very confident that i could of squeezed another 25 hp easy with the meth, mp-8 turned up a little more, and or the timing put back to 2.all in all im very happy.

 

Congratulations!

 

once again nice runs!

 

did they give ya a torque reading for all three runs also ? just gotta know..........

 

well last time it registred at 1338t/q,and 1329t/q at crazy horse and this time i maxed it out at 1450t/q. forgot to tell you mike.

 

14fiddy, dayum thats some serious twist !

 

Last time you had 19K rail pressure, and 653HP, this time you had how much rail pressure and 683HP?

 

Congrats man! Those are some nice numbers.

 

im not to sure big blue, i wasnt driving the truck on the dyno, but i do know now that r/p isnt a problem at all with the new stage3 floor it.i can hold 26.500 in any sw now.also left a little HP on the table by running just water, and keeping the mp-8 at 30%

 

I was hoping you had some definite RP numbers, it would be great to have more data on HP difference between 19K and 25K all else being close to equal.