I am wanting to put a cb in my truck. I have a 07 6spd 4x4 and I can't find any place to put one.. I used to have one in the hole under the radio, but it looks better without the cb there...any ideas??

 

mounted mine by the transfer case side of the center console right between the go pedal and the seat

 

i have the 4x4 shifter in the floor and i mounted my conexx 3300 on the plastic thats around it. works really good and it does not get in the way of the foot.

 

What did you guys do to mount it to the plastic so it would not break out? I'm assuming its pretty thin but i could be wrong, haven't had any of the interior apart in my truck

 

i just used 2 small bolts with nuts and lock washers. its pretty tough

 

Here's mine, its a big case Cobra 29 so its a bit bulky.

 

Here's a link to an old post and what I did. https://www.dieseltruckresource.com/...56#post2321556

 

i have mine like gus03 does

 

https://www.dieseltruckresource.com/...3&d=1245208976

Pretty old school and mediocre but it works fine and doesnt mess up your line of sight any more than the steering wheel, (adjust accordingly for individual height)

 

Mounted mine on the right side of the hump.

 

thats where i mounted mine. i built a little bracket to raise it up so i could reach it easier w/out having to lean over a lot. and i alos angled is towards the back some too so that i could put it farther to the dash to give room for the passenger seat to slide forward some. but i'm happy so far.

 

I did mine like Rick D. I mounted mine into the metal floorboard and run my wires thru the floor

 

On my 04 6speed I mounted mine inside the armrest. Of course the radio was a cheap, small and skinny kind. but it worked great for me. Close the armrest and you would never know I had a radio in there.

 

Genos Garage sells a mount that works with manual trans trucks.
http://www.genosgarage.com/prodinfo.asp?number=WD_CB1

 

I mounted mine on the drivers side of the 4x4 shifter. It's not in the way at all and definitely right at hand!