I was just running low on fuel and have the fass system so on an incline i guess it picked up air and bogged out and almost stalled, then i threw a code for p2146. I guess its because i had no fuel but how do i go upon resetting the codes? I hope it will just go away once i fill up and not pop on again.

 

After three good trips the MIL is extinguished and the Task Manager automatically switches the trip counter to a warm-up cycle counter. DTCs are automatically erased following 40 warm-up cycles if the component does not fail again.

For misfire and fuel system monitors, the component must pass the test under a Similar Conditions Window in order to record a good trip. A Similar Conditions
Window is when engine RPM is within ±375 RPM and load is within ±10% of when the fault occurred.

 

i also have an edge does that have anything to do with it? i have been searching and see everyone has this problem with the edge

 

Beats me. I copied my reply out of the manual. Maybe someone else knows.

 

I've had this come on twice. If you want the "check Engine" light to go off, simple disconnect the batteries for a few minutes. When you hook them back up, it'll be out! I also have the Edge, but never had this issue until I had the "hot" upgrade a year and a half ago. I contacted Edje and they said they were aware of the problem and were working on a solution, but that was a year ago and I haven't contacted them to get a follow-up. Maybe shoot them a line and see what they say.