so im finishing up the exhaust/stack setup on the truck and yes the stock will be in place as well for several reasons.

my question is should i cut the tailpipe? i was just gonna hack it off after it goes over the axel but now that im thinking about it the soot might hit the flat part of the stock trailer and go all over everything... and if i leave it as is i think it wont look right.

do you guys think a black turndown or something comeing out back would make it go down enough to go under the trailer and not hit the front? any other ideas

 

nobody....??????

 

Sorry to say it but stacks on an PU just don't look that good just my opinion

 

If you ran the exhaust straight out the back and then put a turn down on it i bet the air flow from driving would pull the soot right under the trailer.
Will

 

my smoke flows right over top of the 30 ft camper i pull. my old 5 in exhaust that exited in back corner kept the passenger side of trailer black

 

trying to figure out what you are doing ?? You want stacks AND regular exhaust at the same time ??

 

yes.. i really wanted stacks myself but did not want to muffle them and with a trailer on the drone is unberable on the highway... and i haul alot of cattle that are primarly show cattle and cant have any soot going into the trailer.. and being able to switch lets me have stacks when i want and a quiet exhaust that exits out the rear for hauling