So, the basic problem is that the wire going to the A/C sensor is rubbing on the high pressure line.

The wire going to the A/C sensor is the one that is kind of wrapped but is two smaller lines going to the plug with the red tab connector, is this correct?

The high pressure line is the one resting on top of the line going to the A/C sensor. They both come out of the loom by the oil pan??

Big question is.......Is the high pressure line (if I have defined it correctly) rubbing strictly on that plug in module with the red tabs, or is it rubbing where these two lines go into the loom they both come out of???

on another note, getting these massive oil filters out is a pain in the a** and knowing that they constantly get pulled past these wires that are rubbing raw is ironic to say the least.

thank you for any clarification

 

no experts in the house??