Im trying to find banjo to barb fittings for the banjo on the injector pump and the one on the filter. Im doing a veggie oil conversion and I need to switch the fuel source there and I just hate to saw that line in half to do it. =(
I remember there was some talk about this awhile back but I dont think anyone found a source.

 

any hydraulics shop will have it or can get it. M12 x 1.5 metric thread to -6 or -8 barb. depending on how big you want to go.

 

On the 12-valves, at the P-pump inlet the banjo bolt size M14x1.5. At the fuel filter, the size is M12x1.5.

On the 24-valves, the size is M12x1.5, for all locations.

Vulcan has some metric to JIC, but I don't they have the one you want, look here:
http://www.vulcanperformance.com/ser...109/Categories