stjames151

Does anyone know if there is an aftermarket wire harness to run the engine and trans out of an '02 2500. Painless just halted theirs for now and I'm getting desperate.

Totallyrad

When you talked to Painless, did they or could they tell you who might have one in stock. When I searched, this site kept coming up. There's a toll free number at the top of the page. http://www.google.com/aclk?sa=L&ai=B...okupType%3DNON

stjames151

When I say halted, I mean there has been a halt in the publication of release date. They say that they have pushed the release of the combo unit back by several months because of glitches. They say they've NEVER put them out there with the trans controller. They did put them out without it. Dennis Deihl (lead tech for project development) has been keeping me up to date for the last year. I wanted to know if anyone knows of anyone BESIDES Painless that has produced one. It doesn't matter if they use the factory ECM/PCM or their own controller.

Coagulation

Well if you think about it, there really isnt that much that needs to be connected between the ECM and the Engine, not too many sensors and only the connection between the VP and the ECM and thats not too many wires either. If I was you I would start all over and pull out the entire engine harness and go through everything and remove all the un-necessary wires and get the harness so that all you have to do is apply power and ground and make the engine run.