Hey everyone, havent been typing here for quite a while. Been working and working and did I say working. Anyway, I have been leaking at the transfercase tail shaft seal for a little while now. Just wondering if anyone has had this problem. I was hoping to only need a seal since I dont want to pull the tail housing if I dont need to. Last time I replaced one it had to be pressed in. I felt for bushing slop too and it didnt feel so bad. Not tight as a tick but not floppy loose either.

 

A seal is all I needed for mine. Still good in 9k miles.

 

Mine is a 95 but they are probably similar. Used a large (1.75 inch?) socket to drift the new seal in. Has worked fine for me.

 

Any kind of write up on how to do this, mines leaking pretty decent. Thanks. Jim