CKP sensor...where the heck is it! I got the new one and cked around the starter and fuel filter area and have found nothing that looks like what i got. I have cked with Dodge and they said i got the right one. They told me i had to pull the starter but i have looked under and around it and did not see anything to constitute pulling it. I do see a sensor in the side of the block near the starter/f-filter area but its round and plug-in is parallel (Looks like a MAP sensor) to the way it attaches into the block. Not at a 90 like the one i got from Dodge. Any hints?

 

This will help:
http://www.dodge-diesel.org/articles/cps/ckp.htm
Here is a good site for info on repairs, troubleshooting and mods.
http://www.dodgeram.org/tech/dsl/maint/3rd_Gen-24v.htm

 

I think the 01 trucks only had the cam sensor, which is under the VP44.

 

Sorry...didnt say on this new thread.....truck is a 3500 2002. Has lots of bombed crap....so wnty is junk....haha....

 

I should have said 01 and up.

 

Stake's right... his 02 will not have a crank position sensor... it only has a cam position sensor.

Horace

 

Well that explanes the plate that is there instead of the sensor......cool....well now i got to figure out what this blasted prob is now! Truck runs like crap..... https://www.dieseltruckresource.com/...threadid=22688 ...if yall have any hints......here is the thread...thanks!