2002 dodge with edge chip codes and major limp mode
08-20-2012, 08:23 AM
#31
Registered User
Join Date: Sep 2007
Location: Martinsburg, WV
Posts: 216
Likes: 0
Received 0 Likes
on
0 Posts
08-21-2012, 06:29 PM
#32
Registered User
Join Date: Feb 2006
Location: cincinnati
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
Latest news, map sensor has been replaced and the code has not returned however the driveability issue remains. Replaced the turbo and NO difference. $1400 and climbing. BTW I called dodge and complained about their faulty diagnosis and they said that they will figure it out. Does this mean that they will the parts at it until it runs right?
09-19-2012, 08:10 PM
#34
Registered User
Join Date: Feb 2006
Location: cincinnati
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
In case anyone is still watching this thread. Dodge determined that the ecm is bad. Weremoved it to find that they apparently beat the heckler out of it with a punch or hammer. To make matters worse after running a new ground to the ecm it ran perfectly for thirty minutes then died with a no buss code. It appears that all it needed was a good ground but the housing Which is now dented shorted the board.
Thread
Thread Starter
Forum
Replies
Last Post
55_Cans
3rd Gen Engine and Drivetrain -> 2003-2007
3
09-02-2012 02:27 PM
Mark Hodowanec
3rd Gen Engine and Drivetrain -> 2003-2007
3
09-01-2009 08:17 PM
Mark Hodowanec
3rd Gen Engine and Drivetrain -> 2003-2007
4
08-26-2009 05:55 AM