trying to clear up the smoke
Thread Starter
Registered User
Joined: Aug 2009
Posts: 488
Likes: 0
From: Kamloops BC
trying to clear up the smoke
also posted in another sub forum,but i want to contribute here as well.
he351/ S476 83mm primary
..... to help clean up the HUGE 5x18 SDX smokey bastards
pulled the inner fender and heat exchanger
built my mount to support at t6 flange and the bearing area.
only on day two but made a good start
some issues so far
downpipe clearance as to make the hot pipe a nice 90* bent the primary has to move back quite a bit. going to have to get mancy angles to get zero radius bend
not sure how to drain the primary? fitting in the pan.......but what one?
he351/ S476 83mm primary
..... to help clean up the HUGE 5x18 SDX smokey bastards
pulled the inner fender and heat exchanger
built my mount to support at t6 flange and the bearing area.
only on day two but made a good start
some issues so far
downpipe clearance as to make the hot pipe a nice 90* bent the primary has to move back quite a bit. going to have to get mancy angles to get zero radius bend
not sure how to drain the primary? fitting in the pan.......but what one?
Thread
Thread Starter
Forum
Replies
Last Post
Johnsoncattle
3rd Gen High Performance and Accessories (6.7L Only)
50
Nov 27, 2015 08:29 PM
powerchoker05
3rd Gen High Performance and Accessories (5.9L Only)
40
Nov 19, 2005 09:01 PM