stack kit
#17
Registered User
Thread Starter
Join Date: Jun 2005
Location: placerville
Posts: 283
Likes: 0
Received 0 Likes
on
0 Posts
could you just drill out the riviets that hold it in and slide it back a couple of inches redrill and bolt it in place should take an hour or so or cut out section and put an 7x7 steel jig weld it in and run exhaust pipe through it
#19
Registered User
Join Date: Feb 2008
Location: Fresno Ohio
Posts: 219
Likes: 0
Received 0 Likes
on
0 Posts
I like the stacks as close to the front of the bed as possible so when we did my single stack we cut a chunk out of the cross member... with the tool box in there will not be any weight up there. when we put dual 6's on a friends truck we took out part of the bed cross member and about half inch out of a frame cross member. no problems at all.
Thread
Thread Starter
Forum
Replies
Last Post
Topper
3rd Gen High Performance and Accessories (5.9L Only)
6
03-03-2008 10:17 AM
white250005
3rd Gen High Performance and Accessories (5.9L Only)
3
10-25-2007 10:19 PM
B.Law
3rd Gen High Performance and Accessories (5.9L Only)
16
04-22-2005 02:28 PM
Cat Cracker
3rd Gen Engine and Drivetrain -> 2003-2007
2
07-14-2003 12:17 PM