Mainly just wanted to say off road design is a great company they have a awesome technical help line. the products are great quality too

 

Yup, i have used them in the past and would continue to do so.

Northwest Fab on the other hand, not so much....

 

Do they make a crossover steering kit that will plug-and-play on an unlifted First Gen?

 

Nope, In my opinion it is not possible (atleast very unlikely depending on spring age/condition) to put crossover steering on a stock unlifted 1st gen.

2" minimum lift required for crossover.

Offroad design states a 4" minimum for both chev and dodge.

 

I love the ord doubler on my 4bt jeep pickup, the 4:1 low ratio with powerlock axles is unstoppable, I three sticked it to allow front only activity, if your in trouble on the side of a wall, you can save your driving angle by spinning back into line with the climb, practically in place, its saved many a hairy close to roll over situations.