manifold bolts/studs grade?
#1
Registered User
Thread Starter
manifold bolts/studs grade?
While I have the head off I'm going to replace the exhaust manifold bolts. Either stud or bolts. What grade should they be?
Thanks,
Thanks,
#2
Registered User
Join Date: May 2006
Location: York, PA
Posts: 264
Likes: 0
Received 0 Likes
on
0 Posts
I used stainless steel socket head cap screws for mine. I'd use grade 8 in regular steel hardware.
I thought the picture would be bigger. Its kinda hard to see the cap screws. I think you can make the pic bigger in my gallery.
I thought the picture would be bigger. Its kinda hard to see the cap screws. I think you can make the pic bigger in my gallery.
#3
Registered User
Thread Starter
I see the advantage of SS not rusting into the head or manifold. How are they holding up?
I guess SS is strong enough to handle the heat/cool cycles and the expansion/contraction involved?
I guess SS is strong enough to handle the heat/cool cycles and the expansion/contraction involved?
#4
Registered User
Material Coefficient of linear expansion (10-6 in/in)
Cast Iron Gray 6.0
Steel 7.3
Steel Stainless Austenitic (304) 9.6
Steel Stainless Austenitic (310) 8.0
Steel Stainless Austenitic (316) 8.9
Steel Stainless Ferritic (410) 5.5
Thread
Thread Starter
Forum
Replies
Last Post
77machomopar
Performance and Accessories 2nd gen only
2
11-30-2009 11:55 PM
cheapskate
12 Valve Engine and Drivetrain
3
03-09-2007 09:18 AM
Dusty Ratcliff
Performance and Accessories 2nd gen only
7
04-02-2006 11:08 PM
Dave88LX
Towing and Hauling / RV
7
08-02-2005 11:43 PM