Seems like everyone is looking for turbos in these sizes. Anybody know a good place to find used ones? What size is an HX50?

 

Best place to find them used is the CompD classfields. At least that's what I've found to be true. Any site will do I suppose, but CompD seems to be the most active.

 

Compd is where I bought my new one

 

i bought mine at industral injecton and thay have a good warranty for there stuff

 

JQ, i found HX50 specs

http://cgi.ebay.com/ebaymotors/Holse...Q5fAccessories



here's a new one w/ low bid. 22cm housing

http://cgi.ebay.com/ebaymotors/Cummi...Q5fAccessories

 

Main page : http://www.myholsetturbo.com/

HX50 / 55 : http://issuu.com/dieselusa/docs/hols...owFlipBtn=true

Happy reading !!

 

I've got an HX50, it's a 66mm with a 19cm exhaust housing, zero miles on rebuild. just sittn around.

 

Crossy ---
That's an HX50 flange - I've got a 40 with that flange and a 17 cm turbine.
I've noticed a slight hesitation in spool compared to my H1C w/18.5 cm ...

BUT hang on about 1200 RPM in any gear.
When she lights - she lights....
I've stil got stock sticks, new sticks might help the spool some.

 

more fuel will help alot!!!

 

How about going from stock to 6x14 or 6x16 ???
That's my plan --- BUT ----

best laid plans - etc.etc.etc

 

I thin 6x16's would be too big, I don't think anyone has ever tried some 6x14's.. they sound good

 

i agree 6x14 for sure!!!

 

If I went custom size again it would be 6x12's.

 

You know i thought about 6x12's too. they would probably run clean and make good power, If a '435' 5x14 runs as clean as i've seen, a 6x12 should be a nice injector but little pricey at $700 .