Hey all, I've got a question that I'm hoping someone has experience with. My windshield washer pump recently quit responding and upon investigation, I found that one of the wires that goes into the back of the plug has come out. I don't know that I can get it connected back up - what is my best bet on fixing this? Does that part of the wiring harness have plugs on both ends, or can I get a replacement plug with short leads that I can solder on as a replacement?

Thanks in advance,

Waylan

 

Probably want to check a junk yard to snip off the pigtail you need. I'd think any 2nd gen would be the same...

 

Doesn't even have to be a truck. Any of the Jeep line should be the same if not most cars in the yard. Might even find one at a local NAPA. .

 

Thanks guys. I picked one up off a donor truck and will splice it in when I get a chance.

Waylan