Spyntec finished with ball joints and universals
#1
Registered User
Thread Starter
Spyntec finished with ball joints and universals
New rotors with brake pads pretty
Toyo 35 in tires the hub's only stick out the width of the mile marker lockouts
Just need a four and a quarter inch hole saw for the hubcaps and I should be finished
Homemade bearing puller with a 3/4 inch Bolt work great after the Hub was broken loose with the power steering
Universals in
Took 4 hours to D rust Knuckles but they look good after they're painted
Painted and ball joints in
Just finished the spyntec free Spin kit on the front of my Dodge diesel 06 went fairly well will update later here's the pictures
Toyo 35 in tires the hub's only stick out the width of the mile marker lockouts
Just need a four and a quarter inch hole saw for the hubcaps and I should be finished
Homemade bearing puller with a 3/4 inch Bolt work great after the Hub was broken loose with the power steering
Universals in
Took 4 hours to D rust Knuckles but they look good after they're painted
Painted and ball joints in
Just finished the spyntec free Spin kit on the front of my Dodge diesel 06 went fairly well will update later here's the pictures
The following users liked this post:
StealthDiesel (03-30-2018)
#2
Registered User
Thread Starter
Thanks
Just wanted to say thanks about anyone that wrote a post about the free Spin kit that I read to help me make the decision to do what I done ,on this form and any other thanks again
Thread
Thread Starter
Forum
Replies
Last Post
06RAMCTD
3rd Gen Engine and Drivetrain -> 2003-2007
3
10-21-2013 05:10 PM
firebill1720
3rd Gen Engine and Drivetrain -> 2003-2007
20
03-05-2010 09:23 AM