HX35 rework
#2
It is a big help to go on to Holset's website and download the manual for the HX35. It has diagrams and basically walks you through the whole rebuild. I did my Wh1C and didn't really notice any big pitfalls, it can be tough to get the exhaust housing off sometimes but that's about it. Just make sure to clean EVERYTHING before it goes back together and pre oil the turbo before firing up the engine. Good Luck!
#3
Registered User
Thread Starter
Join Date: Oct 2004
Location: St Augustine, Florida
Posts: 755
Likes: 0
Received 0 Likes
on
0 Posts
Thanks crimedog. I was thinking of pulling the fuel solenoid relay and cranking it until I get oil out the bottom of turbo with return line off to make sure the bearings are well oiled.
Thread
Thread Starter
Forum
Replies
Last Post