Different Seats
#2
Registered User
Join Date: Jan 2008
Location: Quinton, New Jersey (middle of nowhere)
Posts: 7,547
Likes: 0
Received 2 Likes
on
2 Posts
Factory buckets from a 1st gen or a Ramcharger are very comfy and hold you in the seat good with the big bolsters on the sides...
If you are short you can swap in a set of 94+ 2nd gen dodge seats...but they put you up alot higher.
Seats out of a 96 into the 93 . used stock 96 mounts.
Look past my kitty and you'll notice how high they sit, but VERY comfy
If you are short you can swap in a set of 94+ 2nd gen dodge seats...but they put you up alot higher.
Seats out of a 96 into the 93 . used stock 96 mounts.
Look past my kitty and you'll notice how high they sit, but VERY comfy
#6
Registered User
Trending Topics
#8
Registered User
Join Date: Oct 2007
Location: savannah ga
Posts: 147
Likes: 0
Received 0 Likes
on
0 Posts
I used a set of mid seats from a dodge grand caravan.They are not just a bolt in job.I had to use a set of back and forth seat tracks from a 1986 lebaron,as well as cut the original mounts from the caravan seats.Way too tall.measure,cut,weld.It was a bit of work,but I picked up the seats at a local junk yard for 20 bucks each.had the lebaron in the back yard.
#11
Registered User
Hey 1bad93 those 80's Ramcharger seats look xactly like my original '93 club cab seats, fabric pattern and color. I wonder how many years they used that material and if it can be purchased to cover a rear bench to match?
#13
Registered User
That's what I want to do, the problem is first finding a decent bench and then finding one the right color! I'm a long ways off from needing an interior but I am looking every time I go to a yard. Quite a few years ago, I ordered one of those center jumpseat/console for the front and they matched the upholstery - but they ran the pattern in the wrong direction!
Thanks
Thanks
#14
The same seats came in Ram Vans until 2000. They all have the same issue of breaking down on the outside. They sure are comfortable before they break down. If they held up I would put a set in my 06.
#15
Registered User
I'm gonna keep an eye out for another drivers side. Probably a good idea to try not to plant full weight on that edge and do the turn and slide, I'll see how that works next time I drive it! They are one of the most comfortable seats I've ever had - especially for a Mopar.