Im looking to upgrade from stock steel wheels and tires on my 98 3/4 t 4X4.

Im wanting to run a 285, 295, 305, or 315 - not sure which. What is the correct backspacing to get for an aftermarket rim? What widths are you guys using? (Id prefer to go with 8")

TIA...

 

Swap the rubber from the 01??? That would give you the right setup to look stock..

 

I have pictures of my new 285 mastercraft courser C/T's in my Gallery. I think they look good. Check Ebay for rims. Some stores on there have great deals. I like a lot of the Eagle Alloy wheels myself.

Eric

 

From what Ive been told - they wont fit without taking some metal off the rear drums and steering knuckle. Dont know for sure

 

I am running 16x8 w/4.5 backspacing. I don't like the tires sticking out too far past the fender, so I went with the 4.5 BS on the Pro-comp Xtreme rims. For tires I am running S.S. Radials 285/75/16, they measure 34" Diameter. See pic in my gallery.

 

Neil - thanks a lot. Just what I was after. Itoo find that the 10" rims stick out too farl.