OK i cant figure out how i am going to hook up my fuel pressure guage when i put my FASS on how are you guys doing it? IM probably going to put it on so any info could help out.

Kevin

 

If its a FASS 150, we got a gauge tap on the pressure manifold (Square block that the pressure line to the IP attaches above the fuel filter). OR you can check out some of these other options:

http://www.powerbypoole.com/fuelpumps.html#dodge

http://www.jegs.com/webapp/wcs/store...0002_746566_-1

 

The power by poole is same way I put mine in my airdog system works very well. Just used diffrent fittings but same principal.

 

Similar setup with my FASS HPFP, just didn't come from PbyP...works just fine with the needle valve in the line going to the gauge.

 

Is there a way to make this because really i would like to have the guage workin when i put it on either today tomorrow or the next day and i really dont want to order that one piece and have to wait a week for it to get here.

 

Sure:

get a 3/8" x 3/8" x3/8" NPT "T",

two 3/8" NPT to 3/8" Barb fittings,

Hose clamps,

and one 3/8" NPT to 1/8" reducer bushing......

This is how i have mine.....(Actually all 1/2" pipe...but same thing really....)

I would bet you could find all of this at Home Depot or Lowes

 

Also NAPA (most I imagine anyway) carries these parts you would need. I did mine similar to this way before going to the HPFP and bigger line.