North Texas DTR#8 - August Meet
Registered User
Joined: Nov 2005
Posts: 7,785
Likes: 3
From: Pattonville, Texas
I'm excited about these new trackbar bushings we're doing!
Relatively cheap, "slippery", easy to install, all hard parts (NO rubber or urethane), no lube required, and available for lifts of from 0-8"... yes - they are machined to adjust the length of the trackbar!
Relatively cheap, "slippery", easy to install, all hard parts (NO rubber or urethane), no lube required, and available for lifts of from 0-8"... yes - they are machined to adjust the length of the trackbar!
Registered User
Joined: Nov 2004
Posts: 5,680
Likes: 2
From: McKinney, TX
Registered User
Joined: Nov 2005
Posts: 7,785
Likes: 3
From: Pattonville, Texas
I see a number of problems there:
bars too short
frame bracket too short
improper welding technique
poor bracket design
floating heim joint
loose hitch pin
excessive drive angle
Exhibit "A" showing how close DIY design, engineering and fabrication can be to "Hold my beer and watch this!" 
bars too short
frame bracket too short
improper welding technique
poor bracket design
floating heim joint
loose hitch pin
excessive drive angle
Exhibit "A" showing how close DIY design, engineering and fabrication can be to "Hold my beer and watch this!"
Thread Starter
Chapter President
Joined: Oct 2002
Posts: 4,983
Likes: 1
From: Sedalia, Texas
Thread
Thread Starter
Forum
Replies
Last Post
crobtex
Natl. and Regional Chapters / Special Events
398
Aug 15, 2009 10:26 AM
crobtex
Natl. and Regional Chapters / Special Events
171
Oct 16, 2007 09:56 AM
crobtex
Natl. and Regional Chapters / Special Events
197
Jun 5, 2007 10:27 AM
crobtex
Natl. and Regional Chapters / Special Events
793
Apr 24, 2007 11:13 AM