Iowa, MN, WI NE, and anybody else close to Iowa
#20
Registered User
Thread Starter
Join Date: Nov 2002
Location: Elma Iowa
Posts: 557
Likes: 0
Received 0 Likes
on
0 Posts
WELL,you guys missed a good time!, not as many showed up as we liked, but, still fun none the less!!Matt worked his butt off all day!, I should Know, cause I had to keep reminding him to pull his pants up!! ha ha!! Got my valves done and new grey valve cover gaskets in , didnt have time to do the timing, might have if we could have got the locking pin out! but IRONHORSE {matt} has got a great place down there and him and his partner are really great guys!! definitly got to have another get together down there sometime!, we had a little trouble timing one truck, but got some others worked on ,and rode in a few that just blew me away!!! I wish we could have got my timing done, but we were also runnin out of time, I needed to get home. I was the last one to leave as I was matts little helper all day!!lol I left my house at 7:00 am, I left his shop at 7:30pm and got home right at 10:00pm, and I think I was sleeping by 10:10!! we will get the timing done sometime, cause I think there will be another get to gether soon!,or we will get it done at Dave G's dyno days. should have been there guys!, better luck next time!
Thread
Thread Starter
Forum
Replies
Last Post
DPG
Suggestions, Comments and Site Questions
14
08-14-2003 05:06 PM
Chillimau
3rd Gen Engine and Drivetrain -> 2003-2007
5
08-02-2003 07:56 AM