Sled Pulling w/TQ Convertor Lock Switch?
#1
Registered User
Thread Starter
Join Date: Nov 2005
Location: Tampa, Fl.
Posts: 617
Likes: 0
Received 0 Likes
on
0 Posts
Sled Pulling w/TQ Convertor Lock Switch?
Does anyone use a TQ Convertor lockup switch while sled pulling? If so when would you engage/disengage it?
#2
Registered User
Join Date: Apr 2006
Location: Norfolk VA
Posts: 284
Likes: 0
Received 0 Likes
on
0 Posts
I have used the switch, 4lo OD locked out, when it shifts to 3rd I lock it up when I see the RPM's start to drop I unlock it.
the last pulls I did with a lot more power and very tough compition it would drop 1000 RPM before I could unlock it. I stated leaving it unlocked and letting it shift like it wanted to, that seemed to work pretty good too.
the last pulls I did with a lot more power and very tough compition it would drop 1000 RPM before I could unlock it. I stated leaving it unlocked and letting it shift like it wanted to, that seemed to work pretty good too.
#3
Registered User
Join Date: Dec 2003
Location: Garrard county, Kentucky
Posts: 3,077
Likes: 0
Received 0 Likes
on
0 Posts
I have 3:55's, and 2nd gear is good for the power i have, so when i get into 2nd, I lock it, and dont unlock it till im completely stopped, and spinning.
Eric
Eric
Thread
Thread Starter
Forum
Replies
Last Post
0425004x4
3rd Gen Engine and Drivetrain -> 2003-2007
4
02-16-2006 07:16 AM
mr T
Performance and Accessories 2nd gen only
21
06-01-2005 08:48 AM