first time at the track
first time at the track
60ft...2.86
330ft...7.46
1/8et...11.09
1/8mph...69.14
1000et...14.13
1/4et...16.72
1/4mph...87.86
Winner .61 against a pretty nice trans am
I only made one pass cuz it was midnight madness and the lines were ridiculous. I think i can shave at least a full second off if i can get the launch down.
330ft...7.46
1/8et...11.09
1/8mph...69.14
1000et...14.13
1/4et...16.72
1/4mph...87.86
Winner .61 against a pretty nice trans am
I only made one pass cuz it was midnight madness and the lines were ridiculous. I think i can shave at least a full second off if i can get the launch down.
well I would think You should be a low 15 with the mods you have...You can definately do better on the launch. Just keep practicing not too bad for the first time. My first time I ran a 16.2 @ 81 stock. Then a 14.86 @ 91 with just an intake, exhaust and tst powermax. You will get there just takes a little practice
Rowing gears is pretty hard I imagine
Rowing gears is pretty hard I imagine
Did you air down your rear tires? 35 psi is a good place to start. Some guys run as low as 20 psi without slipping tires in the beads and without the use of bead locks like the 4x4 Jeep guys use.
Thread
Thread Starter
Forum
Replies
Last Post
Luken
Competition / Pulls / OffRoad
3
Jun 17, 2006 10:33 PM



