4th gen, 6.7-to-G56 pressure plate torque specs
#1
Registered User
Thread Starter
Join Date: Apr 2015
Location: Searsport, ME and Fountain, FL
Posts: 6
Received 0 Likes
on
0 Posts
4th gen, 6.7-to-G56 pressure plate torque specs
Hello all,
Someone previously posted the correct torque specs for flywheel, pressure plate, etc. for this 4th gen 6.7/G56 combination and unfortunately, I can't seem to re-locate that post.
Can anyone tell me where to find that link or what those specs should be?
One of the typical loads I haul
Someone previously posted the correct torque specs for flywheel, pressure plate, etc. for this 4th gen 6.7/G56 combination and unfortunately, I can't seem to re-locate that post.
Can anyone tell me where to find that link or what those specs should be?
One of the typical loads I haul
Last edited by truckmen; 11-25-2017 at 05:57 PM. Reason: adding a photo or 2
#3
Registered User
Thread Starter
Join Date: Apr 2015
Location: Searsport, ME and Fountain, FL
Posts: 6
Received 0 Likes
on
0 Posts
I have 194,000 miles on it now. In fact, today, I finally completed the clutch install.
The G56 is doing okay except when I coast downhill with the engine brake on; the transmission will pop out of high gear so I have to hold the stick but I think I know what I did; some months ago, I stupidly took a full load of cars through Death Valley in the middle of the day instead of just going around. Ever since then, I have this problem with the G56. I believe the syncro is gone.
Ralph
Thread
Thread Starter
Forum
Replies
Last Post
robby t
3rd Gen High Performance and Accessories (5.9L Only)
1
05-03-2013 08:58 PM
lniemeyer2
3rd Gen Engine and Drivetrain -> 2003-2007
1
10-24-2012 12:11 PM
dmill
1st Gen. Ram - All Topics
2
12-11-2011 12:00 PM