Cummins Power Shifter knob
Enaf, what's the reason for the shifter with that bend in it?

I replaced the center seat section with a hotbox subwoofer enclosure. All would've been well, but the 12" JL W6 sub I used required the box to be a few inches taller than usual. This, combined with the Geno's smoothie cupholder and the Jacob's exhaust brake switch, prevented me from being able to shift into 4th and 6th gear!
So, the solution was to get out the welder and acetylene outfit! After a few hours, I had everything fitting perfectly. The shifter is slightly higher to match the raised center section, and the shift pattern stays entirely within the little indent on the driver's side of the smoothie.
--Eric
Thread
Thread Starter
Forum
Replies
Last Post
DISTURBED
Performance and Accessories 2nd gen only
29
Aug 31, 2011 03:35 PM
kcbarnes
3rd Gen High Performance and Accessories (5.9L Only)
20
Jan 20, 2007 01:39 AM



