I may replace the torq converter anyway when i tear down the tranny and see the damage from the shaft break, I have been told to run a 15 blade left cut converter. Any suggestions at to what type of converter will be great. Keep in mind my 37's with 4:10 gears and the BD R-700 Twin Turbos. What convertor will be the best fit for my mods? Triple or a good single disc?

 

I would get a triple or better yet call Dave G. or another builder and get their opinions

 

I'm setup very similar, running a suncoast triple n its really smooth. So i'd say triple disk

 

Same here, I love the Suncoast 3 disc I have, my turbo doesn't though

 

Just to give you another place, Dunrite does a pretty good job as well. Tony is his name and has awesome products.

 

Duk, I really think you need to get rid of the BD VB if that's what you still have.

 

I sure like my Sun Coast triple.
Topper

 

Suncoast triple.

 

Why ditch the BD VB?

 

The only one that offers an unconditional lifetime warranty is Dave Goerend. If you break a shaft and it hurts the TC, it get replaced for free.

 

I am leaning towards the 15 blade left cut from Dave Goerend. I hear thats what he likes to put in trucks with twins.

 

DUK, you could also send your converter up to Spec-Rite for them to go through and adjust accordingly.

I love my Spec-Rite!!!

 

Whats the turn around and price look like. As long as the break didn't damage it

 

Talk to Erik tomorrow about the cost...the time I figure should be no more than a week. They are located in Redding....so a couple of hours away..should not take too long.

I do know this...as long as the converter isint shattered....it will cost way less than a new one!!!

 

Thanks Less, i will talk to Erik. See you tomorrow