New to the forum, not to Dodge. Just bought my fourth 3500, first time to have an Auto though. Already looking a little leary at it. Came with the Edge EZ, pulled it off at the guys house before leaving and ordered a Smarty Jr same day. Installed Intake, Exhaust, and bags, haven't got my Pyro, Boost, or Trans gauges in yet. So here is my question, what is a safe setting to run on until I get my gauges in the truck? It will be over road miles with no trailer until I get the gauges in, might have small cargo trailer. Truck won't even know its there though.

So what I would like to know is what is safe for the trans too? Like I said, never had an Auto, I know what I could run on all my 6 speeds. But never experimented with this setup. Any help would be greatly appreciated.

Smarty Jr. is V:5.12A

 

I'm running mine on sw3, all defaults, just taking it easy till I get my gauges installed....

still waiting for a fuel pressure gauge

 

No guages for me yet either. I will have a Edge Insight CTS soon. From what I have read, and gathered from those on this site that already have a Jr, all of the settings should be safe. It is different than the regular Smarty and set up so it can be ran without gauges. I think the literal translation is, "if you don't get crazy with it, you'll be fine." I just got my Jr. a few weeks ago and I set it at SW3 TM4 TQ2 PoD 80. Although I drive like an old man and don't tow. , I will occasionally give the long pedal a brief goose. It just has to be done!
I'm sure some others will jump in on this and give you some more good info. I have learned a lot from them.