Here are some pics of my new ats manifold and II silver 62 turbo.Should I have the exhaust housing ceramic coated to match the manifold

 

How do you like it? Hows the spool-up with the auto? and any towing?

HotRod

 

I like if so far I need to drive it more . I just made a pass down the road and the edge said 14.2 in the 1/4 mile I was spinning bad

 

looks good buddy

 

Niceness. You could give it the same coating but I think it looks good like this.
what does that setup roughly cost by the time you drive away or is it none of my business?

 

$200 ceramic coating
$500 for the manifold
$2000 about for the turbo

 

Very nice setup. If I can't save up enough for Twins you pretty much have what I would do. I tow a lot but like to play a bit as well. How are your EGT's? Lag? Any HP/TQ figures yet? Nozzles? Sorry for all of the questions but you literally have a setup I am thinking about. Thx -Steve

 

Also, who did the coating on the Manifold and is it a big foot?

 

The coating was sent out by powder coat finishes of Baltimore Md. The egts do not get hot unless I turn the edge on . I hope to get some hp numbers in oct and still have stock nozzles hope to get 90hp soon. the manifold is an ats. If anyone has one coated bolt it up first I had a fun tie mounting it.

 

Please post on this thread when you get some numbers etc. I'm anxious to hear them.

 

I am more wondering about the bolts haha I cant seem to locate metric bolts with a small enough head to clear my afe manifold. The ones you have would be handy. thanks

 

mcmaster carr Is where I got them 10mm 1.5 20mm long . They have the in stainless with a hex head . You should use some kind of lock washer