Yes it yet another EGT question.

I just installed my pyro guage and was wondering if there is any way to test it to make shure it is reading right.

It is installed pre-turbo right on the manifold on the down pipe right before it goes onto the turbo housing.

There are no mods to speak of only thing on it is a K&N filter and a 4in straight exhaust pipe right from the turbo back no muffler, no cat.


Ex: Running at norm temp for me is 200 @55-60 mph nothing in bed or tow best guess of what it should read.

Pav

 

Something isn't right with the gauge/probe. It will idle higher than 200* and cruise at around 500-800*.

 

Oh sorry that was the eng temp there(200) not EGT's.

Pav

 

What he said. I usually see between 600-800 during normal driving conditions. I let my truck idle until I see less than 300 before I shut it down. Good luck
-Jeremy

 

I took it out tonight and thats about were it ran at, around 65mph it was 650 to 675,cooled down to below 300 in less then a min.

Pav