I am replacing the fuel injectors. Is the fuel injector removal tool Miller tool 9010 a must have or a nice to have?

 

once you back out the connector tube, and remove the two screws holding down the injector, wrap a rag around the top and slowly pull up.... the will come right out....

 

I found a screw to thread into the injector (maybe 8mm) and lightly pried each out.

 

Thanks for the info. I thought as much. The tool was $160. I had allready removed and re-installed the feed tubes to check and clean them and that called for a special tool as well. I just carefully pulled them out.

thanks again