24 Valve Engine and Drivetrain Discuss the 24 Valve engine and drivetrain here. No non-drivetrain discussions please. NO HIGH PERFORMANCE DISCUSSION!

Fueling Problem at Start?

Old Jan 16, 2013 | 10:25 AM
  #1  
DieselVeins's Avatar
Thread Starter
Registered User
 
Joined: Aug 2007
Posts: 54
Likes: 2
Fueling Problem at Start?

Recently my truck will not start sometimes and I am out of ideas as to why. Sometimes it will start the first time I crank it, and other times it won't start for ten minutes. Also sometimes when it won't start I turn the key on and off a few times then it cranks right up. I have had it turn on in the drive way for a second then cut off. I put in a new crankshaft position sensor yesterday and that didn't do the trick. I've been told my truck doesn't have a fuel solenoid, so I don't really understand how the fuel gets told to be sent and then shut off. I'm sure it is some electrical problem where fuel is not getting sent because it cranks without any problem but won't fire sometimes. I am all out of ideas so any help is greatly appreciated! The adrenaline is not on the truck right now.
Reply
Old Jan 16, 2013 | 01:32 PM
  #2  
lovinCTD59's Avatar
Registered User
 
Joined: Jul 2006
Posts: 762
Likes: 0
From: Minnesota
Do you have a fuel pressure gauge? If so what's your fuel pressure?... If not I would get one!

If its not throwing any codes, first I would suggest looking at the entire fuel system to make sure there isn't a place that air is entering the fuel causing the hard starting.
Reply
Old Jan 16, 2013 | 04:30 PM
  #3  
patdaly's Avatar
Administrator
 
Joined: Jan 2007
Posts: 8,372
Likes: 172
From: Streator Illinois
Yep, could be a loss of prime, would explain why it starts after bumping the key a few times ( reprimes ).

Fuel pressure gauge is the first step.
Reply
Old Jan 20, 2013 | 09:42 PM
  #4  
TOM R's Avatar
Registered User
 
Joined: Feb 2008
Posts: 493
Likes: 1
From: Va. and n.j.
my truck has had this problem ever since I had the engine ecm replaced and the dealer did the "software update" which aparently changed how the lift pump operates at start up

my truck used to fire right off with almost no cranking also the lp used to run for a long time when the key was turnred to the on position and prime the injector pump

ever since the update turn the key forward and there is no pressure since the lp runs for afraction of a second wait for the light to go out and start cranking till it runs, if I bump the key the pump will run like it used to just don't like to do that

all I see this update doing is wear out my starter faster, this update was done 4+ years ago
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
keithw1975
24 Valve Engine and Drivetrain
6
Aug 16, 2006 05:34 PM
banzaitoyota
1st Gen. Ram - All Topics
17
Mar 21, 2006 03:07 AM
gsdog1
Performance and Accessories 2nd gen only
1
Jan 6, 2004 04:27 PM
Rattletrap1
2nd Gen. Dodge Ram - No Drivetrain
6
Jul 30, 2003 01:14 AM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 04:04 AM.