Anyone know what the threads are on those banjo fittings? I'm thinking of changing some plumbing around but I'm not sure what threads these are.

 

I don't know what the thread per cm is but these fit. The 14mm is for the mechanical lift pump.

Jim

 

Those M12 fittings are what you need. IIRC it's 1.75 thread pitch. I used fittings very much like those -8 x M12 to plumb 1/2 fuel hose all the way through my transfer system whe I relocated the transfer pump. works good.

 

Just been through this, 12x1.5 mm, it is one of the ISO fine threads. Like Noseeum said, Vulcanperformance.com sells the JIC adapters to these for $7.50 or so.
-P

 

ah there you go, bad memory on my part.