I changed the lower and upper ball joints but they still wont align because they said the lower passenger side is bad??? So I pulled it back apart and upon closer inspection the lower ball joints seat (angle part) is worn some WFT it didnt break off or anything like that. So how do I go about fixing it its part of the whole dam axle assembly. Kinda need this thing fixed as Im heading to Canada SOON and I am need of a alignment.

96 2500 4x4 reg cab Cummins

 

how, EXACTLY did you set\install the joint?

 

I installed it the same as drivers side. Put the new joints in and tightened evenly, not top 1st then bttom. Also I didnt us a air gun ect..I dont like using them during assembly. Did I go astray somewhere in the process?

 

That sounds ok to me, I was just making sure you didnt set the truck on it or use a jack?

sorry I dont have better advice?