GSK install tool problem
01-13-2006, 09:05 PM
#1
Registered User
Thread Starter
Join Date: Aug 2004
Location: Va Beach
Posts: 845
Likes: 0
Received 0 Likes
on
0 Posts
GSK install tool problem
What did you guys use to pull those square nuts off? I dont have have a square (8 pt) socket that big here and sears, autozone, and advance quite selling them 
I tried using a pair of needle nose vice grips and that was no dice.
I tried using a pair of needle nose vice grips and that was no dice.
01-13-2006, 09:43 PM
#3
Registered User
Thread Starter
Join Date: Aug 2004
Location: Va Beach
Posts: 845
Likes: 0
Received 0 Likes
on
0 Posts
Pulled the 7/8" plug under the fuel shut off solonoid behind the linkage. Barred the motor over and got the springs to come up. They had a center post like the directions show but the retaining nut looks like a 9/16" square nut.
01-13-2006, 09:49 PM
#4
Registered User
Thread Starter
Join Date: Aug 2004
Location: Va Beach
Posts: 845
Likes: 0
Received 0 Likes
on
0 Posts
Nevermind. I got it now. Combo of bad directions xerox copy and my own terminal case of of dumb a!! Sorry guys. One the good note I did git the #10 plate in.
Thread
Thread Starter
Forum
Replies
Last Post
Mkinner
Performance and Accessories 2nd gen only
2
09-21-2010 07:57 PM
Need95-00CTD
Performance and Accessories 2nd gen only
8
04-26-2007 10:05 AM
MR HYDROSEED
Performance and Accessories 2nd gen only
6
03-09-2005 10:49 PM
Got Smoke?
Performance and Accessories 2nd gen only
7
10-26-2004 03:57 PM