quad adr/pulse
#1
Registered User
Thread Starter
Join Date: Dec 2008
Location: aberdeen
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
quad adr/pulse
ok guys i just put this thing in today runs great. But i went out tonight trying to get the smoke and power got the power but not that much smoke. I adjusted the fuel press gauge setting on it up to 8 instead of five thought it might help it did i had WOT at the light some smoke and then i let off the accelerator cause i got behind another car and then my truck completely died. was that because of not enough fuel or what. And if you guys could give me some pointers on getting more smoke to.
#2
Chapter President
did it restart?
What was and is your fuel pressure?
Is the CEL on?
I've seen this happen if your under hard WOT then let really fast it kinda runs the injector lines empty, you usually have the crack a couple injectors to get the air out.
What was and is your fuel pressure?
Is the CEL on?
I've seen this happen if your under hard WOT then let really fast it kinda runs the injector lines empty, you usually have the crack a couple injectors to get the air out.
Trending Topics
#8
Registered User
I noticed you said you adjusted the fuel pressure gauge on the pulse. That only makes it read higher, its for fine tuning in case its a little off. If you turned it up it could read 5psi when its really at zero know what i mean? What did you have for fuel pressure when it was at set at 5?
#9
Registered User
Oh and for fuel systems, after screwing around with holleys and carters, it will be worth it just to do an airdog right away. I wish i would have from the start, it would have saved me time and money in the long run.
#13
Chapter President
Join Date: Jun 2007
Location: Elk River, MN
Posts: 1,124
Likes: 0
Received 0 Likes
on
0 Posts