boyeraz

Please post your egt Pictures of 3 gen.

Also how due you keep the metal bits out of the line?

Thanks

RamWheelsBy4

Lots of threads on how to drill and tap the exhaust manifold for pyro sensor. Go slow, use grease on drill bit and tap, use magnet, leave engine running, drop turbo a little and put something to cover, etc. Just do a couple of searches until you find a process that you can do.

Here is picture of my first pyro sensor followed by picture of the second pyro sensor installed about an inch farther back on the manifold.

truckjunkie

If you're looking for a pic of a post-turbo install, there's a couple in my gallery.

boyeraz

Ram wheelsby4

Due also have a picture of the boots install

thanks

gerry

how is this...

Some drop their turbo and tape it like I did, some use small drills and slowly step up so the chips are very small, some drill with grease and partially cover their tailpipe and drill while the truck is running to blow the stuff out...

All methods seem to work pretty well... I went the ultra safe route, dropped the turbo and taped it off.. I was also able to put my finger up in the port and feel the depth of the pyro..and make sure the holder was flush inside.

Gerry

Luvnacumns

Here is both!!

SHane

CRXsi

There are also some useful pics of the pyro install in my gallery as well.

RamWheelsBy4

Used boost bolt, easiest install.