Gauges to replace cupholder?
Thread Starter
Registered User
Joined: Feb 2004
Posts: 63
Likes: 0
From: Evansville IN
Gauges to replace cupholder?
Does anyone make something to replace the worthless cupholder in the 94-97 trucks? I would like to add a few more gauges and was jus lookin to see if I could get any ideas or pics to go by.
Thanks
Kroner
Thanks
Kroner
Registered User
Joined: Dec 2003
Posts: 14,672
Likes: 9
From: Montana
Check the classifieds over at TDR
http://www.turbodieselregister.com/c...lassifieds.cgi
There was a fellow there selling a cover plate to replace the cupholder for like under $10.
I agree on the worthless holder, on most every dash I remove the stereo is covered with sticky cola goo. Couldn't be good for the electronics.
Better bet is the Smoothy Cup Holder form Geno's that goes on the front of the center console.
http://www.turbodieselregister.com/c...lassifieds.cgi
There was a fellow there selling a cover plate to replace the cupholder for like under $10.
I agree on the worthless holder, on most every dash I remove the stereo is covered with sticky cola goo. Couldn't be good for the electronics.
Better bet is the Smoothy Cup Holder form Geno's that goes on the front of the center console.
Thread
Thread Starter
Forum
Replies
Last Post
nevems2ret
3rd Generation Ram - Non Drivetrain - All Years
2
Nov 8, 2006 11:04 AM
tomm
3rd Generation Ram - Non Drivetrain - All Years
2
Jun 19, 2006 01:21 PM
lynnhowlyn
3rd Generation Ram - Non Drivetrain - All Years
22
Dec 16, 2003 01:31 AM