what size exhaust housing is on the 3b? looks good man

 

26cm housing

 

good deal is that the stock 12cm housing on the hx35?

 

yea with the wastegate bored out to 1". not hard to build, just time consuming. the whole twin setup is cheaper than a new single and should run better so i figured why not. hopefully running by friday, saturday at the latest. then im taking it down bretts sunday to get an o-ringed head put on. still looking for a wastegate actuator if anyone comes accross one.

 

http://www.racingjunk.com/category/2...-golfcart.html

got me a new toy, hopefully i can get to it before TS

 

a nasty day of rain but it aint stoppin me!

 

Does anybody have a 5 inch hole saw. Putting in stacks into buddys truck. Need by sat.

 

Word of advice if you havent used a 5" metal hole saw before....Don't use a Battery Drill to do it. With a corded drill at least the cord can wrap around your arm when it catchs the bed support. .

Rick

 

I have a 4.5" and a 6", but not a 5" I used the 4.5" on mine.

 

Looks good Eric!

 

Here ya go Mark, some stuff you might be interested in.
http://www.competitiondiesel.com/for...ad.php?t=53892

 

Uh Oh. Timing slipped hardcore this morning. Whited out 4 lanes of traffic. No restart. Travis is coming up tonight to help retime it. Anyone know if i can just go to 16. I was reading and it doesnt seem as dangerous as i thought.

Mike

 

16 degrees is fine. ive been at 16.5 for a while and pushed over 40lbs of boost through my hx35 (darn ddp4's and i just put it to the floor). head gasket still in tact! until this sunday when my head gets ripped off. when am i building your twins? hahaha

 

Eric are you gettting a 20over gasket? i have one in the garage

 

yea im doing the 20 over... the one you have looks like something you would pick up on baltimore screet, all beat up and nasty lookin.