1 or 2 Stacks For My Pulling Rig???
 

Just trying to get the public's opinion on what really looks better - 1 or 2 stacks on my pulling rig? I was thinking 2-6" stacks two feet apart that stand about 3 feet above the cab with flappers....just for pulling events?

flappers 3' over the cab.[yuk] For you're truck I'd do a single 7" miter, just to the right of the rear slider. 2" above the cab.

one 6 in stack the same height as the cab, no flapper

i agree with willy off center looks mean and its simple just a 90 up into the bed

I would definately have it 2 maybe 3 inches higher than the cab max with no flapper, I'm not a big fan of single stacks, they just don't look right imo.

One or two I think they both look good. At a max of 4 or 5 inches above the cab. No flapper. Sorry I jus don't like flappers.

I would think that either one would look good, especially miter cuts. One stack or two stacks would look pretty mean. The smallest I would go would be 5, maybe 6 inch stacks.

One stack!

one eight inch out the hood![guitar]

a pair of black 6" miters or a single 7" maby, But ya know i like to be different...Wes carrier bearing is in just waiting on you...

put side pipes on it 6" turn outs from wheel to wheel

1 6" out the hood miter cut!!! NO 3FT OVER THE CAB[yuk] U will get joked unless u win.

X2 Make it a 6" just off center to the right and mitre cut with top even with cab height

cab high single 7"...no flappers please[nonono]
duals are for V8's[tapdshut][coffee]






















easy you dual guys I just playin:cool:

I second the single I would go 7" though